Hammer Mills: Industrial Mills, Commercial Mills, Farm Mills, American Made, Made in the USA, Commercial Grinders, Industrial Grinders, Feed, Seed, Grain, Coffee, Herb, Spice, Corn, Wheat, Bone, Grinders, Mills, Pulverizer, Pulverizers

Call our Engineering Department Toll Free to discuss your Grinding Needs: 1-888-201-6785

Hammer Mills are durable utility grinders capable of grinding most free-flowing materials.  Hammer mills operate on the principle that most materials will grind or crush upon impact with the hammers.  The material is fed into a hammer mill from the top and gravity falls into the grinding chamber.  The material is contacted by a series of rotating hardened hammers.  The material is ground by repeated contact with these hammers, contact with the walls of the grinding chamber, and particle to particle contact.  The material remains in the grinding chamber until it is suitably sized to pass through the perforated screen that covers the bottom half of the grinding chamber.  We offer interchangeable screens with hole diameters from 2" to 1/64" to allow for coarse or fine grinding of most any product.  The output (volume) of the hammer mill is dependent upon the screen size, shaft speed (normally 3,600 rpm), and the configuration of the hammers.  We can configure our hammer mills to best suit your application.  We are happy to test grind any product free of charge.  If you are interested in sending a product for test grinding please contact Engineering toll free at 1-888-201-6785.  By test grinding your product we are able to prove the capability of our hammer mills and determine the proper model and set up (bottom discharge or material handling fan, and belt drive or direct drive) to suit your needs.  We offer hammer mills with bottom discharge (gravity fall) and we offer hammer mills equipped with material handling fans (recommended for finer grinds).  Hammer mills may  be belt driven or direct driven to fit your specifications.  Our engineering staff is also available to assist in designing a system to efficiently handle your product.  Whether you need a complete layout or simply need to fit a new piece of equipment into your existing layout, our staff is available to assist you. 

#5 Hammer Mill w/Fan and Motor.	#25 Hammer Mill w/Fan	#35 Hammer Mill Bottom Discharge w/Motor
#65 Hammer Mill Bottom Discharge	#85 Hammer Mill w/ Fan Discharge

Rotor assembly in a #85 Hammer Mill

Please note that the model #35 is available with the standard feed opening, 15" x 11", and with a flared feed opening, 18 1/2" x 11".  The model #35 is also available with the standard 1/4" side plates or with a heavy modification that increases the thickness of side plates to 3/8".

Top